A Gatewood company - serving Enterprise, NV

Ghost Controls Keypad & Intercom Repair in Enterprise, NV

Wrought ironWrought iron
Wood & steel frameWood & steel frame
Farm & ranchFarm & ranch
Sliding driveway gatesSliding driveway gates
LiftMaster operatorsLiftMaster operators
Every visit starts with

Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted

The assessment is free and the quote is the invoice.

Get your free estimate

Ghost Controls Keypad & Intercom Repair: The Enterprise Owner’s Guide

We repair and replace Ghost Controls keypads and intercoms in Enterprise, and most jobs run $185 to $420 installed, depending on whether we’re swapping a keypad alone or a keypad-plus-intercom setup. A failed keypad usually means your gate won’t open from the driveway, and a dead intercom means you can’t see or talk to whoever’s at the gate. Both bring the same result: you’re out of the car, in the dark, or on the phone with a visitor who can’t get your attention. If that sounds familiar, you’re not alone. The heat and dust around Enterprise chew through outdoor access-control parts faster than a homeowner expects. Here’s the straight version of what’s likely failing, what it costs, and when to call.

Call (833) 780-1547

Key Takeaways

  • Most Ghost Controls keypad and intercom repairs in Enterprise run $185 to $420 installed, quoted and agreed before any work starts.
  • Keypad and intercom failures usually trace to sun-cracked housings, corroded terminals, or a battery backup that gave out months ago.
  • A no-trip-charge service call inside Clark County means we can look before you commit.
  • We’re an independent service provider, not affiliated with Ghost Controls.

Which Ghost Controls Models This Applies To

Ghost Controls builds its keypads and intercoms around a handful of accessory lines, and fitting the wrong one is the most common mistake we correct in Enterprise. The wireless keypad family (the AXWK and similar models, plus the connected versions) mounts on a post or wall and talks to the operator by radio, which means the receiver board inside the operator has to match the transmitter’s frequency. The wired keypads run low-voltage wire back to the control box, and they’ll only work if your operator has that input. Intercom and video-intercom units add a whole layer: they tie into the same power and the same accessory terminals, and if your gate motor wasn’t set up for one, it won’t just plug in.

To identify what you have, pull the serial and model label off the keypad housing (usually behind the faceplate) and off the operator’s control board cover. Match both. The accessory has to be compatible with the operator you’re running, not just the brand name on the gate. On the OEM-versus-aftermarket question for Ghost Controls specifically: the factory keypad is the safest compatibility bet, but a quality aftermarket unit built for the same radio and terminal layout does the job at a lower price, and we’ll tell you honestly which makes sense for your gate. Parts get ordered against your exact model, so there’s no guessing and no second trip.

Explore

Styles & brands we work with

  • Wrought iron
  • Wood & steel frame
  • Farm & ranch
  • Sliding driveway gates
  • LiftMaster operators

Signs Your Ghost Controls Keypad & Intercom Repair Is Failing

Most Enterprise owners find out the keypad died the same way: they punch the code in and nothing happens, or the gate opens for the fob but not the keypad. These are the symptoms we see, and what’s usually behind them.

  • The keypad lights but the gate won’t move. The unit has power, but the code isn’t reaching the operator. Usually a lost pairing between keypad and receiver, or a corroded terminal where the accessory meets the board.
  • The keypad is dead, no lights at all. Often a battery backup that expired or a failed low-voltage connection. Sun-cracked housings let rainwater in and take the board with them.
  • You have to press a code several times, or it works only up close. Radio range falls off when the receiver antenna or the keypad’s internal antenna degrades, and it always gets worse in the heat.
  • The intercom crackles, echoes, or drops the call. A worn push-to-talk switch or a damaged speaker/mic element. Dust and sun exposure are hard on the little plastic parts.
  • No video or a black screen on a video intercom. The camera module or the low-voltage power feed has given up. One of the two is the culprit most of the time.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

In Enterprise, a straight keypad replacement typically lands between $185 and $260 installed, and a keypad-plus-intercom swap runs $280 to $420 or more depending on the model and the wiring route. What drives the range: whether the existing wiring is sound, whether we’re matching to a buried line or pulling new low-voltage, and whether you’re going wireless or wired.

  • Diagnostic and identification of your exact Ghost Controls model
  • Removal of the failed keypad or intercom and disposal
  • Re-mounting and weatherproofing at the post or wall
  • Pairing or wiring to your operator, then a full function test on the gate
  • 90-Day Done Right Promise in writing, labor included

Parts and labor are broken out on the written estimate, and the price is quoted and agreed before any work starts. No surprises when the invoice lands. We don’t stock parts on a truck and we don’t claim to carry a warehouse; we order against your model and come back ready. There’s no trip charge inside the county, $40 off any repair over $200, and a free second opinion on any written estimate you already have.

DIY or Call Us?

Not every keypad problem needs a service call. You can safely check that the operator powers on, confirm the keypad has fresh backup batteries, and re-pair a wireless keypad to the receiver if you have the instructions. Those are the low-risk steps.

Where DIY goes wrong is the low-voltage wiring and the operator board. Access-control terminals carry low voltage, but the operator itself is tied to line voltage that can seriously hurt you, and miswiring an accessory can kill the control board. We don’t hand out how-to instructions for opening the control box, because that’s exactly where a homeowner gets bitten. One honest paragraph instead: if the gate opens from your remote but not the keypad, or the intercom is dead, that’s our lane. Call (833) 780-1547 and we’ll get eyes on it.

FAQs

How long does a Ghost Controls keypad or intercom last in Enterprise? Most outdoor keypads need replacing in six to ten years, and intercoms often go sooner because UV exposure and dust chew the plastic and electronics. You can stretch that with a shaded mount and a fresh backup battery now and then. Call (833) 780-1547 if yours is acting up.

Can the keypad or intercom be repaired instead of replaced? Sometimes, yes. A lost pairing, a corroded terminal, or a cracked housing we can reseal on site is a repair, not a replacement. When the board or the mic element is gone, replacement is the cheaper road. We’ll tell you which you’re facing. Call (833) 780-1547 for an honest answer.

How long does the swap take? A keypad swap is usually under an hour, and a keypad-plus-intercom replacement typically runs one to two hours once the part’s on hand. The part gets ordered against your model, so plan the visit around delivery. Call (833) 780-1547 and we’ll line it up.

How do you source the part? We identify your exact Ghost Controls model and order the matching keypad, intercom, or a quality aftermarket equivalent built for the same layout. You get a written price before we order. No-trip-charge inside the county, and a free second opinion on any estimate you’re holding. Call (833) 780-1547.

Whether your gate access is down in Enterprise or a nearby spot, the name’s on the shop and a live person answers the phone around the clock. We also service LiftMaster, Mighty Mule, and DoorKing. Call (833) 780-1547 for a free estimate.

Written by the team at Gatewood Fence & Gate Enterprise, serving Enterprise and nearby areas.

Need Gate Repair help nationwide? Licensed & insured · 30-60 min response · free estimates
Call (833) 780-1547
Local Service Coverage

Request a Free Estimate in Enterprise

Tell us what you need - Gatewood Fence & Gate Enterprise responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Us
Call Now - 24/7 Dispatch