Wood & steel frame
Wrought iron
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Repair Before & After in Enterprise, NV
A sagging gate, a motor that grinds, a weld that let go in the wind: you can describe the fix all day, but seeing the before and after is what actually tells you whether a crew knows what it’s doing. Here are recent Gate Repair jobs around Enterprise, NV, the problem we found, what we did, and what the gate does now. Each photo gets dropped in as jobs wrap, captioned by service so you know exactly what you’re looking at.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Recent Transformations
Sagging Driveway Gate Reset Back Into Square
Before
AfterThe gate had dropped until it dragged the concrete and only shut when you lifted it. A gate sags in the hinge post, not in the middle, and that is where we start. We checked the post footing, re-set the anchor hardware, trued the frame, and rehung both leaves. It now latches with one hand and clears the ground on its own swing.
Galvanized Tube Gate Re-Welded On-Site
Before
AfterA cracked weld at the hinge let the gate flex and catch on the latch post every time it closed. We weld on-site, so the gate never left the driveway. The cracked joint was ground out, re-welded, and braced, then we checked the opposite hinge while we were in there. The gate swings clean and the latch lines up first try.
Sliding Gate Opener Repaired, Not Replaced
Before
AfterThe sliding gate would close on the car and refuse to reverse, which is a safety problem, not a nuisance. We found worn guide rollers binding the track and a travel limit that had drifted, not a dead motor. We replaced the rollers, reset the limits, and verified the safety edges. The gate now stops and backs off the moment it meets an obstruction.
Manual Swing Gate Converted and Motorized

What started as a repair call turned into a retrofit: the gate was sound but the household was tired of getting out in the desert wind to open it. We mounted an opener, ran the power properly, and installed the safety edges and photo-eye. It’s measured and scheduled work, not a same-day drop-in, so we quoted a written price first. The gate now opens from the car and stops for anything in its path.
Rusted Hinge Post Replaced Before the Frame Went


The gate felt loose and hung low, and the paint was bubbling at one corner of the post. Fix the panel without the post and you’ll fix it twice. We cut out the rusted post, set a new one, and rehung the gate onto it. The panel we saved does what it should, and the gate is square again instead of fighting its own hardware.
Keypad and Entry System Back Online

The keypad had gone dead and nobody could get the gate to open from the pedestal. We traced a corroded connection in the entry wiring, cleaned up the terminals, and tested the keypad, remote, and intercom together. Everything is talking to the gate again, and the homeowner can hand out codes instead of spare remotes.
Want Results Like These?
Show us the gate closing on its own and we’ll show you where it’s failing. Call Gatewood Fence & Gate Enterprise at (833) 780-1547 for Gate Repair in Enterprise, NV. Every job carries the 90-Day Done Right Promise in writing, with upfront pricing agreed before we start, a $40 discount on any repair over $200, no trip charge inside the county, and 10% off for seniors and veterans. Estimates are free.
Written by the team at Gatewood Fence & Gate Enterprise.
See the difference
Before
After
Before
After
Before
After