Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGhost Controls Gate Motor & Opener in Enterprise: What to Know First
We service Ghost Controls gate motors and openers in Enterprise as an independent Ghost Controls service provider, and most repair calls we take here are diagnosed and finished within a week – many inside two visits. You’ll get a written price before a wrench comes out of the truck, and it won’t move when the job is done. If you’re in the Highlands, out toward Riverside or up in the foothills where the wind never quits, and your gate has started running slow, stopping halfway or ignoring the remote, this page was written for you. Call (833) 780-1547 and a live person picks up.
Key takeaways: Ghost Controls is a DIY-friendly brand, which means we often find the install, not the motor, behind a failure. We repair first, replace second, and every job carries our 90-Day Done Right Promise in writing.
How Ghost Controls Products Fail – and How We Fix Them
Ghost Controls is a solar-and-low-voltage brand built for the do-it-yourselfer, and that shapes how their units fail. Here are the five patterns we see most often in Enterprise.
- Terminal block corrosion on the tank-style solar units. The TS and TDS series run on low-voltage DC, and the exposed terminal blocks along the control box soak up moisture during our monsoon stretch. The motor is usually fine; the connection is not. We clean and re-terminate with a proper seal and test amp draw, which tells you in ten minutes whether anything deeper is wrong.
- Battery backup that never charges. On the HT and AR series with solar panels, a panel that’s drifted into shade or collected dust will quietly stop charging. Owners see a gate that works after sundown but quits by morning. We test the panel output and battery voltage separately before we sell you either one, because we’ve replaced batteries on jobs where the real culprit was a $6 connector.
- Limit switch drift after a hard wind. Ghost Controls arms are light, and an oversized gate swinging in a strong Enterprise gust can knock the limit settings loose. The gate stops in the wrong place or reverses without warning. Realigning the limits and checking the arm bracket is the fix – new hardware rarely is.
- Underpowered operators on heavy gates. This is the DIY-install trap. A Ghost Controls unit rated for a light residential gate gets bolted to a wide, heavy metal gate and strains for years before the gearbox lets go. If that’s your situation, we’ll tell you straight that a different operator or a smaller gate opening is the honest answer.
- Remote and receiver pairing gremlins. When a remote stops working, owners assume the operator is dying. Usually it’s a receiver board, a dead remote battery or a re-pairing issue. We test the receiver before we touch the motor.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Ghost Controls Gate Motor & Opener Process
- 1
The call. A live person answers, day or night. We ask what the gate is doing, what model you have, and when it started.
- 2
Diagnostics. The person who shows up tests the whole chain – power or solar, battery, control board, limits, arm and hinges. We don’t condemn a motor until we’ve proven it’s the motor.
- 3
The parts decision. OEM Ghost Controls parts keep your warranty path clean. In some cases a quality aftermarket part makes better sense, and we’ll explain the trade-off in plain terms so you decide with your eyes open.
- 4
The repair. On-site. If welding is needed on a bracket or post, we do it in your driveway so the gate stays put.
- 5
The test. Full cycle, force and safety-reverse check, remote range check, and a walk-through with you before we pack up.
- 6
The promise. Your 90-Day Done Right Promise is stamped in writing. If something isn’t right, one call brings us back.
See the difference
Before
After
Before
After
Before
AfterWhat Ghost Controls Gate Motor & Opener Costs in Enterprise
Every price below is a real range we quote in Enterprise, and it’s fixed before work starts. No surprises at the door.
- Diagnostic visit: free second opinion on any written estimate; no trip charge inside the county.
- Battery or solar panel replacement: $120-$320 installed, depending on the model line and panel.
- Limit switch / receiver / control board repair: $150-$400, most often at the lower end.
- Motor or arm replacement: $350-$900 depending on whether the unit is a light swing arm or a heavier slide operator.
- Full new operator install with intercom or keypad integration: $900-$2,200 for the operator and integration, scheduled not same-day.
What moves the price: gate weight and width, whether the wiring is existing or needs a fresh run, whether you want a battery backup added, and which Ghost Controls model you own. Seniors and veterans get a permanent 10% off, and any repair over $200 gets $40 off – no haggling. Call (833) 780-1547 for a free estimate.
Why Enterprise Homeowners Call Gatewood Fence & Gate Enterprise for Ghost Controls Work
We’re owner-operated and locally accountable – the name is on the shop, the address is published, our techs have up to 25 years of experience, and the person who answers the phone at 2 a.m. is a live human, not a voicemail. We repair what other outfits want to replace. When your Ghost Controls unit needs service, we show up with the knowledge to fix it and the honesty to tell you when a different operator is the smarter long-term answer. We also service LiftMaster, Mighty Mule and DoorKing, so if you own more than one gate on the property, one call covers all of them. Every job is background-checked and stamped with the 90-Day Done Right Promise in writing.
FAQs
Yes – in most cases, as long as we use OEM parts where the warranty path matters. We’ll talk through that at the estimate so you’re not caught off guard. As an independent Ghost Controls service provider, we don’t speak for the manufacturer, but we’ll stay on the right side of the warranty whenever it makes sense. Call (833) 780-1547 for a free second opinion on any written estimate.
Yes. We can source OEM parts for the TS, TDS, HT and AR series and stock the common pieces – batteries, receivers and remotes – so most repairs are one-visit fixes. Unusual control boards may take a few days to order. Call (833) 780-1547 with your model number and we’ll tell you what’s in stock.
Repair first, almost always. A control board or limit switch repair is a fraction of a new operator, and a well-cared-for Ghost Controls unit will give years more service after a proper fix. We only recommend replacement when the gearbox or motor is genuinely worn out or the unit is underpowered for your gate. Call us for a straight answer.
Repairs, usually within a day or two, and we handle emergencies around the clock because calls are answered 24/7. New installs and intercom integration are scheduled – that work is measured and quoted before we set a date. Call (833) 780-1547 and we’ll give you an honest window.
Yes. We test solar panel output, battery voltage and the charge controller separately, install new batteries and panels, and set the system up so you actually have backup power when the grid goes down. Most Enterprise solar installs here are a one-visit job. Call (833) 780-1547 for a free estimate.
We integrate keypads, intercoms and access control with Ghost Controls operators, but that work is measured and quoted in advance rather than done same-day. Call (833) 780-1547 to schedule a free estimate.
If your Ghost Controls gate in Enterprise is running slow, stopping halfway or ignoring the remote, call (833) 780-1547 and a live person will pick up – day or night. We’ll diagnose it, quote you a price before we start, and stand behind it with the 90-Day Done Right Promise in writing. Free estimates, upfront pricing and no trip charge inside the county.
Written by the team at Gatewood Fence & Gate Enterprise, serving Enterprise and nearby areas.